Great Planes Phazer EDF ARF - GPMA1802 - Manual (Page 5)

5
ASSEMBLY INSTRUCTIONS
Ducted Fan Assembly
Reference the separate HyperFlow instruction sheet as
necessary, but follow the instructions below for assembly/
installation into the Phazer.
❏
1. Enlarge the hole in the fan housing to allow installation
and removal of the motor without having to remove the brass
fan adapter.
❏
2. As shown in the HyperFlow manual, trim the three
alignment guides from inside the housing to accommodate
the motor.
❏
3. Trim any fl ashing from around the fan housing so the
fi berglass cone adapter will fi t correctly.
❏
4. Key one of the 3mm set screws (for fastening the brass
fan rotor adapter to the motor shaft) onto a 1.5mm Allen
wrench—a basic “L” wrench is included if you don’t have one
of your own. Use a metal fi le to lightly fi le down the end of the
screw—it won’t take much—just a few passes to remove the
slightest fraction of an inch.