Great Planes Sequence 1.20 EP/GP ARF - GPMA1232 - Manual (Page 9)

9
Fiberglass
Wheel Pant
4-40x3/8" [10mm] Phillips
and #4 Flat Washers
5-32" [4mm]
Wheel Collar
#6 Washers
(as spacers) 6-32" Set Screw
❏
4. Mount the wheels and wheel pants as shown—don’t
forget to use threadlocker on all the screws.
❏
5. Mount the main landing gear in the fuselage with
#8 x 1/2" [13mm] SHCS (socket-head cap screws), #8
lock washers and fl at washers—note that the inner screw
on each gear leg uses no washers so the heads will not
protrude too much above the fuel tank/battery plate. As you
have been doing all along, be certain to use threadlocker on
all the screws.
❏
6. Mount the tail wheel with a 3/32" [2.4mm] wheel collar
and a 4-40 set screw and threadlocker.
Prepare the Fuselage for Mounting
the Engine (or Electric Motor)
❏
1. If using the O.S. 1.55 FS-a, remove the bottom cutout
for the muffl er. If using a brushless electric motor, remove all
the other cutouts instead. Use epoxy to seal the MonoKote
around F-1, the seams around the cutouts not removed and
the edges of the cutouts you did remove.
Vertical Tick Marks
Horizontal
Tick Marks
Angled
Tick Marks
Angled
Tick Marks
❏
2. If mounting a glow engine drill 1/16" [1.6mm] pilot
holes through the fi rewall at the four horizontal and vertical