Great Planes ElectriCub Kit - GPMA0156 - Manual (Page 9)

❏ 4. Pin the die-cut 3/16" balsa stab frames S-2 and S-3 in
position. Glue S-2 and S-3 to S-1 and the stab TE.
❏ 5. From the 3/16" x 3/16" x 24" balsa stick, cut and glue
the stab ribs to the stab frame. Glue the 3/16" die-cut balsa
stab gussets S-4 to the stab TE and S-5.
❏ 6. Remove the stab from your building board. Inspect,
glue and sand as you did with the fin.
❏ ❏ 7. From a 3/16" x 3/8" x 30" balsa stick, cut the elevator
leading edge to length and pin it over the elevator plan. Pin
and glue the die-cut 3/16" balsa elevator frame E-1 through
E-4 to the LE.
❏ ❏ 8. From the 3/16" x 3/16" x 24" balsa stick, cut and glue
the elevator ribs to the frame.
❏ 9. Repeat steps 7 and 8 to build the second elevator half.
❏ 10. Remove the elevators from your building board.
Inspect, glue and sand as you did with the fin.
❏ 11. Pin both elevators in position over the plan. Lay the
3/32" elevator joiner wire on top of the elevators in the
position shown on the plan. Use a pencil to lightly mark the
outline of the joiner wire on the elevators.
❏ 12. Using a straightedge, extend the side lines of the
elevator joiner outline forward to the leading edge. Also, use
a Precision Hinge Marking Tool to draw a centerline on
the leading edge. Using these lines, you can determine
exactly where to drill the holes for the elevator joiner wire.
9