Great Planes Super Sportster (original) - Manual (Page 18)

33. D GLUE ON THE 1/4" x 1/4" BALSA TOP STRINGER
Cut to length and glue the 1/4" x 1/4" balsa stringer
in place between formers 3A/3B and 6A/6B.
34, D ADD FORMERS 4A AND 5A
Locate the positions of formers 4A and 5A by
placing a straight edge along the top stringer. Place and
glue the formers so they mate with the stringer and are
centered from side to side.
35. D ADD THE 1/8" x 1/4" STRINGERS
Add the 1/8" x 1/4" balsa stringers by gluing them
at 6A/6B first, checking with a straight edge and then gluing
to 5A, 4A and 3A/3B.
36. D PREPARE AND GLUE IN THE SIDE NOSE
BLOCKS; FINAL SAND THE FUSE FRONT
Groove the inside of the nose side block (right or
left depending on your engine) for the throttle linkage
clearance. Using 5 minute epoxy, glue the nose side
blocks in place. Remove excess epoxy at the chin block
joint. Carve and rough sand the hood top, hood sides and
chin block to the shape of the nose side pieces.
18