Great Planes 27% Extra 330S ARF - GPMA1413 - Manual (Page 33)

33
Apply the Decals
1. Use scissors or a sharp hobby knife to cut the decals from
the sheet.
2. Be certain the model is clean and free from oily fi ngerprints
and dust. Prepare a dishpan or small bucket with a mixture
of liquid dish soap and warm water–about one teaspoon of
soap per gallon of water. Submerse the decal in the soap and
water and peel off the paper backing. Note: Even though the
decals have a “sticky-back” and are not the water transfer
type, submersing them in soap & water allows accurate
positioning and reduces air bubbles underneath.
3. Position decal on the model where desired. Holding the decal
down, use a paper towel to wipe most of the water away.
4. Use a piece of soft balsa or something similar to squeegee
remaining water from under the decal. Apply the rest of the
decals the same way.
GET THE MODEL READY TO FLY
If you’ve assembled your Extra 330S 1.60 ARF with a
glow or gas engine, skip directly to “Check the Control
Directions” on page 34.
Install & Connect the Motor Battery
❏
1. Remove the propeller. IMPORTANT: Whenever setting up
or working on an electric-powered model, always remove the
propeller in case of accidentally providing power to the motor.
❏
2. Before you can power the radio system and set up the
controls, the motor batteries will need to be charged. Never
charge the motor batteries while they are in the model. Always
remove the motor batteries from the model while charging.
IMPORTANT: If using multiple battery packs that are connected
with an adapter, never charge the batteries together through the
adapter. Always charge each battery pack separately. Charge
the batteries, then read the following precautions on how to
connect multiple packs for fl ying the model:
Battery Precautions/Connecting Batteries
This is how to connect four batteries in Series:
Connecting batteries in “Series” means to connect the +’s
to the –’s and the –’s to the +’s. This combines the batteries’
voltages, but the capacity remains the same.
This is how to connect three batteries in Series:
Batteries of different voltages, but not different capacities
may also be connected in Series: