Great Planes Cherokee Kit - GPMA0180 - Manual (Page 19)

15. D GLUE IN THE LANDING GEAR BLOCK
AND GUSSET
Use 5 minute epoxy to glue the Landing Gear As-
sembly in place. Add the small pine gusset under the out-
board (outer) end of the Landing Gear Block. Put a small
amount of glue at each end of the groove to keep foreign
matter out of the wing.
16. D GLUE THE TWO 1/8" PLYWOOD DOWEL PLATES
TO THE WING PANEL
Remove the 1/8" Plywood Dowel Plates from the
razor cut sheets. The smaller Dowel Plate glues to the rear
of the wing panel Leading Edge. The larger Dowel Plate
glues to the front of the Top and Bottom Spars. Use epoxy
and glue both Plates in position between Ribs #1 and #2 as
shown on the plan.
17. D ADD THE 3/32" BALSA BOTTOM LEADING EDGE
SHEETING TO THE WING PANEL
Use the same method that you used to glue on the
Top Leading Edge Sheeting.
18. D GLUE THE 3/32" BALSA BOTTOM TRAILING
EDGE SHEETING IN PLACE
You can roll the Trailing Edge of the wing back so
it is flat on the work surface when you glue this sheeting in
place. Realign the panel again when the glue is dry.
19