Great Planes Edge 540 FlatOuts 3D EP ARF - GPMA1113 - Manual (Page 13)

❏
21. Snap the ailerons onto the wing TE.
❏
1. Install a 2 x 17mm [5/64" x 21/32"] axle and axle
support (D1) onto each landing gear leg. Make sure that
the axles are perpendicular to the centerline.
❏
2. Slide the wheels onto the axles and secure them with a
wheel collar (D6). The flat side of the wheel collar should be
toward the wheel. Secure the wheel collar with a drop of glue
in the
teeth opposite the wheels. Align the wheels with the
centerline and secure the axles and supports with a drop of
glue through the holes in both sides of the axle supports.
❏
3. Make two wheel pants by gluing the inner and outer
wheel pant parts together. Be sure to make a right and a
left. Glue the inside of both wheel pants to the wheel collars.
❏
4. Snap the tailwheel (D5) into the tailwheel bracket (D4).
❏
5. Slide the tailwheel bracket over the rudder and rudder
post. Glue the bracket to the rudder only. Do not glue the
bracket to the rudder post.
Finish the Landing Gear
13