Great Planes Extra 330S 3D E-Performance ARF - GPMA1543 - Manual (Page 18)

18
❏
6. Glue the two hatch dowels halfway into the holes in the
front of the battery hatch. Glue two magnets into the battery
hatch with medium CA as shown. Do not use too much CA
because it may prevent the magnets from sitting fl ush inside
the holes. If the magnets do not sit fl ush with the hatch bottom,
use long nose pliers to carefully press them in place. A light
skin coating of thin CA over the magnets that overlaps onto
the wood frame of the hatch will help secure the magnets in
place. Let the CA glue harden without accelerator.
❏
7. Glue two magnets into the fuse for the battery hatch. Be
sure that the magnets are glued with the correct polarity
facing out! The magnets in the fuse must be attracted to the
magnets in the battery hatch.
❏
8. Test fi t the battery hatch onto the fuse.
INSTALL THE COWL, CANOPY & SPINNER
❏
1. Prepare the inside of the cowl by lightly scuffi ng it
with 220-grit sandpaper. When satisfi ed, clean the inside
with alcohol.
❏
2. Glue the four plywood magnet back pieces to the cowl
ring. Glue a magnet into each of the four holes in the cowl
ring by coating the insides of the holes with medium CA. A
light skin coating of thin CA over the magnets that overlaps
onto the cowl ring will help secure the magnets in place. Let
the CA glue cure without accelerator.
❏
3. Glue four magnets into the holes in the fuse as shown. Be
sure that the magnets are glued with the correct polarity
facing out! The magnets in the fuse must be attracted to the