Channel radio setup, Get the model ready to fly, Set the control throws – Great Planes Fokker Dr-1 60 ARF - GPMA1380 User Manual

Page 26: Check the control directions, Standard mode 2)

Advertising
background image

1. Turn on the transmitter and receiver and center the trims.

If necessary, remove the servo arms from the servos and
reposition them so they are centered. Reinstall the screws that
hold on the servo arms.

2. With the transmitter and receiver still on, check all the

control surfaces to see if they are centered. If necessary, adjust
the clevises on the pushrods to center the control surfaces.

3. Make certain that the control surfaces and the

carburetor respond in the correct direction as shown in the
diagram. If any of the controls respond in the wrong direction,
use the servo reversing switches in the transmitter to reverse
the servos connected to those controls. Be certain the control
surfaces have remained centered. Adjust if necessary.

Use a Great Planes AccuThrow (or a ruler) to accurately
measure and set the control throw of each control surface as
indicated in the chart that follows. If your radio does not have
dual rates, we recommend setting the throws between the
low rate and the high rate. NOTE: The throws are measured
at the widest part of the elevators, rudder and ailerons.

IMPORTANT: The Fokker Dr. I ARF has been extensively
flown and tested to arrive at the throws at which it flies
best. Flying your model at these throws will provide you
with the greatest chance for successful first flights. If, after
you have become accustomed to the way the Fokker Dr. I
ARF flies, you would like to change the throws to suit your
taste, that is fine. However, too much control throw could
make the model difficult to control, so remember, “more is
not always better.”

These are the recommend control surface throws:

High Rate

Low Rate

ELEVATOR:

1" [25mm] up

3/4" [19mm] up

1" [25mm] down

3/4" [19mm] down

RUDDER:

1-3/4" [44mm] right

1-1/4" [32mm] right

1-3/4" [44mm] left

1-1/4" [32mm] left

AILERONS:

3/4" [19mm] up

1/2" [13mm] up

3/4" [19mm] down

1/2" [13mm] down

Set the Control Throws

CARBURETOR WIDE OPEN

RUDDER MOVES RIGHT

LEFT AILERON MOVES DOWN

RIGHT AILERON MOVES UP

ELEVATORS MOVE UP

4-CHANNEL

TRANSMITTER

(STANDARD MODE 2)

4-CHANNEL RADIO SETUP

TRANSMITTER

4-CHANNEL

TRANSMITTER

4-CHANNEL

TRANSMITTER

4-CHANNEL

Check the Control Directions

GET THE MODEL READY TO FLY

26

Advertising