Great Planes Giant Aeromaster ARF - GPMA1225 - Manual (Page 21)

❏
5. Use two rubber bands to hold the fuel tank in place
as shown.
❏
6. Connect the fuel lines to your engine setup as needed.
❏
1. Locate the flexible white nylon pushrod, two 2-56 x 4"
[102mm] threaded pushrods, nylon FasLink, nylon clevis,
and a clevis retainer.
❏
2. Solder the 2-56 threaded brass coupler to the non-
threaded end of a 4" [102mm] pushrod. Bend the pushrod as
shown and thread it into one end of the white nylon flexible
pushrod at least 14 turns. Thread a nylon clevis with silicone
clevis retainer onto the threaded end of the bent pushrod.
❏
3. Slide the white pushrod into the throttle pushrod
tube that is preinstalled in the fuselage and connect the
clevis to the throttle arm on the engine.
❏
4. Mount the throttle servo as shown in the photo.
❏
5. Thread the remaining 4" [102mm] pushrod into the
white nylon pushrod 14 turns. Align the pushrod with the
servo arm and mark where the pushrod crosses the servo
arm. Make a 90° bend in the pushrod at this point and
attach it to the servo arm using a nylon FasLink connector.
Cut the excess pushrod off leaving 1/16" [1.6mm] extending
past the FasLink as shown in the sketch.
Install the Throttle Servo & Pushrod
(Gas Engine)
21