Great Planes Matt Chapman CAP 580 Giant ARF - GPMA1285 - Manual (Page 18)

❏
1. Assemble the stopper, brass tubes and steel stopper
end plates as shown.
❏
2. Solder the brass barbs to the ends of the brass tubes.
Note: Get the tubes just hot enough for the solder to flow. If
you get the tubes too hot it will damage the tank stopper.
❏
3. Attach the clunks to the short brass tubes with 5"
[127mm] pieces of fuel line.
❏
4. Install the stopper assembly in the tank with the vent
line toward one of the longer sides of the tank. Mark that
side of the tank as top.
❏
5. Mount the tank to the tank tray with two #64 rubber bands.
❏
6. Mount the tank tray to the fuse with four #4 x 5/8"
[15.9mm] screws and #4 flat washers.
❏
7. Install the fuel lines. One clunk line goes to the
carburetor; the other clunk line is for filling; the vent line gets
routed out the bottom of the fuse.
❏
1. Slide the cowl over the engine onto the fuselage. Use a
Dremel tool with a cutting bit to trim the cowl where necessary
Mount the Cowl
Assemble and Install the Fuel Tank
18