Get the model ready to fly, Optional combat setup – Great Planes P-51 Mustang Fun Force EP ARF - GPMA1192 User Manual

Page 13

Advertising
background image

1. Insert a rubber band as shown.

2. Lay one end of a colored streamer over the mount.

Insert one loop of the rubber band through the loop at the
other end. Pull it tight to hold the streamer in place.

3. Secure the antenna to the fuselage. If left to trail the

plane, it could become damaged in combat.

1. Turn on the transmitter and receiver and center the

trims. If necessary, remove the servo arms from the servos
and reposition them so they are centered. Reinstall the
screws that hold on the servo arms.

2. With the transmitter and receiver still on, check all the

control surfaces to see if they are centered. If necessary, adjust
the V-bends on the pushrods to center the control surfaces.

3. Make certain that the control surfaces and the motor

respond in the correct direction as shown in the diagram. If
any of the controls respond in the wrong direction, use the
servo reversing in the transmitter to reverse the servos
connected to those controls. Be certain the control surfaces
have remained centered. Adjust if necessary.

Use a Great Planes AccuThrow

(or a ruler) to accurately

measure and set the control throw of each control surface as
indicated in the chart that follows. If your radio does not have
dual rates, we recommend setting the throws at the low
rate,
or sport rate setting.

Note: The 3D throws recommended are extreme throws and
should only be flown by experienced pilots. They are very
sensitive and could cause the plane to seem uncontrollable
to a novice pilot. Sport rates are perfect, and recommended
for, combat and general aerobatic flight.

Note: The throws are measured at the widest part of the
elevators, rudder and ailerons.

These are the recommended control surface throws:

High Rate/3D Rate

Low Rate/Sport Rate

ELEVATOR:

3-1/2" [89 mm] up

1-1/2" [38 mm] up

3-1/2" [89 mm] down 1-1/2" [38 mm] down

RUDDER:

3-1/2" [89 mm] right 2" [51 mm] right
3-1/2" [89 mm] left

2" [51 mm] left

AILERONS:

3" [76 mm] up

1-5/8" [41 mm] up

3" [76 mm] down

1-5/8" [41 mm] down

Set the Control Throws

Check the Control Directions

GET THE MODEL READY TO FLY

The EP P-51 Mustang ARF was designed with the intention
that two or more of these easily built, fun to fly models could
be outfitted with streamers and used for combat. If you
intend to fly combat with this model, you will need to attach
the optional streamer mount using the instructions below.

Optional Combat Setup

13

Advertising