Great Planes RV-4 Park Flyer Kit - GPMA0010 - Manual (Page 16)

❏
C. Make the second 90° bend downward.
❏
D. Make the final 90° bend (twist) upward to form the “Z.”
❏
E. Cut the excess wire near the end.
Note: This procedure does not work for all types of wire, but
will work on the thin music wire supplied with this kit.
❏
10. Connect the aileron servo to the aileron torque rods
with the pushrods you just made.
❏
11. If you need to tweak the linkage slightly to center the
ailerons, you can make a slight bend in the aileron torque rod.
❏
12. After the model is covered, glue the aileron torque
rod bearings to the trailing edge of the wing with medium
CA. Coat the torque rod with a film of oil or Vaseline
® to
prevent CA from adhering to the torque rod.
❏
1. Glue a 1/8" x 1/8" [3.2 x 3.2mm] balsa stick to the top
and bottom on one side of formers F2 to F8. Note: The side
with the sticks on it is now the front.
Frame the Sides
BUILD THE FUSELAGE
16