Great Planes Ryan STA Electric Kit - GPMA0165 - Manual (Page 17)

❏ ❏
34. From the remaining 3/32" x 1/2" [ 2.4mm x 12.7mm]
stick used for the sub LE, cut and glue wing tip braces on
the top and bottom of the wing tip.
❏ ❏
35. From the remaining 1/4" x 3/4" [6.4mm x 19mm]
stick used for the LE, cut and glue wing tip filler blocks on
the top and bottom of the leading and trailing edges.
❏ ❏
36. Use a razor plane and sanding bar to shape the
LE and wing tip to the shape shown on the wing plan.
❏
37. Return to step 2 and build the left wing panel.
❏
1. Draw centerlines along the width and the length of the
two die-cut 1/16" [1.6mm] plywood forward wing joiner and
aft wing joiner.
❏
2. Using the centerlines as a guide, use epoxy to glue the
forward wing joiner centered on the aft wing joiner.
❏
3. Carefully cut a slot in the root rib of both wing panels
to allow the wing joiner to be inserted. Also cut a notch,
extending the wing dowel slot through the LE.
❏
4. Check the fit of the wing joiner in each wing half. The
main spars and TE on both wing halves should meet. With
Join the Wing Panels
17