Great Planes Spirit of St. Louis ARF - GPMA1152 User Manual
Page 9
❏
8. Insert the landing gear support wires into the landing
gear strut cover and, using two 2 x 12mm wood screws,
secure the landing gear and front strut into the precut holes
at the front of the hatch.
❏
9. Secure the landing gear braces with 2 x 10mm
wood screws.
❏
10. Using 2 x 10mm wood screws, secure the secondary
struts to the fuselage. The front of the strut should be even
with the front of the former.
❏
11. Cut a 1-1/4" [32mm] long slot along the centerline of
the bottom of the fuselage, starting 1" [25mm] from the
tail end.
❏
12. Using 6-minute epoxy, glue the tail skid into the slot
you just cut.
❏
13. Trim the corners of the battery hatch to clear the wing
struts. Use a sharp #11 blade, and remove a little bit of
material at a time until you have a good fit.
❏
14. Use a very small amount of epoxy to glue the wheel
covers to the wheels.
9