Great Planes Super Sportster 90/120 Kit - GPMA0214 - Manual (Page 4)

OTHER ITEMS REQUIRED
Propellers (see engine instructions for size)
3" diameter Spinner
Fuel Tank (14 - 16 oz. or larger)
(Larger tanks require custom fitting)
2 - 3" diameter Main Wheels
1 - 2-3/4" diameter Nose Wheel
(or)
1 - 1-1/4" diameter Tail Wheel
4 - 3/16" Wheel Collars for Main Wheels
2 - 5/32" Wheel Collars for Nose Wheel
(or)
2 - 3/32" Wheel Collars for Tail Wheel
Iron-on Covering Material
Silicone Fuel Tubing
Foam Wing Seating Tape
Foam Rubber Padding, 1/2" thick
Dummy Pilot Figure (2-1/2" - 3" tall)
2 - DuBro E-Z Connectors (or similar)
"Y"-Connector (for double elevator servos)
SUPPLIES AND TOOLS NEEDED
2-3 oz. - Thin CA Adhesive Pliers
2 oz. - Medium or Thick CA Adhesive Screw Driver
2.5 oz.- 5 Minute Epoxy T-Pins
2.5 oz.- 30 Minute Epoxy Straightedge
Hand or Electric Drill Masking Tape
Drill Bits (No. 53. 1/16", 5/64", 3/32" 7/64", Sandpaper, (Coarse, medium and fine grit)
1/8", 5/32", 3/16", 11/64", 13/64", 1/4", 5/16" T-Bar sanding block, or similar
Sealing Iron Waxed Paper
Heat Gun Balsa Filler
Hinge Slotting Tool 1/4-20 Tap
Hobby Saw (X-Acto Razor Saw) Tap Wrench
X-Acto Knife, #11 Blades Dremel Moto Tool or similar (Optional)
******************************************************
COMMON ABBREVIATIONS USED IN THIS
BOOK AND ON THE PLANS:
Stab = Stabilizer
Elev = Elevator
LE = Leading Edge (front)
TE = Trailing Edge (rear)
Lt = Left
Rt = Right
" = Inches
Fuse = Fuselage
LG = Landing Gear
Ply = Plywood
4