Great Planes Super Sportster EP ARF - GPMA1160 - Manual (Page 9)

❏
5. Using a sharp hobby knife, cut the covering and balsa
sheeting from the inside of the aileron servo tray area. Trim
only the covering from the outer aileron servo tray area.
❏
6. Use CA to glue the aileron servo tray to the top of the
wing centered over the servo opening.
❏
1. Trim the covering from the two bolt holes at the trailing
edge of the wing.
❏
2. Test fit the wing to the fuselage and bolt it into position
with two 3x30mm machine screws and 3mm washers.
❏
1. Using a sharp hobby knife, remove the covering from
the stabilizer slot at the aft end of the fuselage. Also remove
the temporary balsa block.
❏
2. Mark the center of the trailing edge of the stabilizer.
Insert the stabilizer into the slot.
❏
3. Stick a T-pin into the center of the top of the firewall.
Tie a small loop in one end of a 36" [910mm] piece of non-
elastic string such as K&S #801 Kevlar thread. Slip the loop
in the string over the T-pin.
Mount the Stabilizer and Fin
Mount the Wing
ASSEMBLE THE FUSELAGE
9