Great Planes U-Can-Do 3D EP ARF - GPMA1275 - Manual (Page 7)

❏
5. When you are satisfied with the alignment of the wing,
glue it in place with hot-melt glue.
❏
6. Use hot-melt glue to secure four hinges in the precut
slots in each aileron. Do not worry about a little excess glue
squeezing out onto the hinge pivots–it is easily removed
with a hobby knife after the glue hardens.
❏
7. Test fit the ailerons to the wings. If necessary, enlarge
the precut hinge slots with a hobby knife.
❏
8. Glue the outermost hinge into the wing, making sure
to keep the hinge line parallel with the TE of the wing.
❏
9. Using the flex of the aileron to allow you to glue one
hinge in at a time, work your way inward until all four hinges
are glued in place.
❏
10. Use a hobby knife to clean any excess glue from
the hinges.
7