Great Planes Yak-55 EP 3D ARF - GPMA1190 - Manual (Page 10)

❏
4. Glue a control horn into this slot from the right side of
the airplane.
❏
5. Push a control horn retainer onto the back side of the
rudder control horn. Secure it with a drop of glue.
❏
6. Install the rudder pushrod in the same manner as the
elevator pushrod.
❏
7. Cut slots in the ailerons in the positions shown.
❏
8. Glue control horns into these slots from the top.
❏
9. Push control horn retainers onto the backs of the
aileron control horns. Secure the retainers with a drop of
glue each.
❏
10. Install the aileron pushrods with the Z-bend through
the servo arm. Secure the pushrods to the control horn with
a micro FasLink.
❏
1. Solder the output wires of your ESC to the motor. The
positive side of the motor is marked with a red dot. The
output wires should be soldered to the same connection
post as the presoldered capacitors and brush wires.
Install the Motor & Speed Control
10