Great River Electronics MIXMASTER 20 - Manual (Page 6)

BASIC OPERATIONS: (Continued)
To set pan position, reselect the channel, then instead of pressing LEVEL, press
PAN, rotate SELECT to put the signal in the desired position (indicated by the
green and single center red LEDs), then press and hold SAVE and the SELECT knob
again.
You can select multiple channels and assign levels, then go back and pick the odd
numbered ones in the group and set pans to the left, reselect the evens, set pans
to the right without altering the levels previously set. This is helpful when setting
up multiple stems.
To remove channels from the mix bus, select them first, then press the CHAN
button again, push and hold the SELECT knob and press CLEAR.
To solo a channel, or group of them, select by pressing the CHAN button and
rotating and pressing the SELECT knob as above, then press SOLO. This will mute
any other channels in the mix, or if the solo buttons on channels 1 thru 4 are
pushed at the same time they will also be heard. To clear a solo group, press
CLEAR, unless you have accidentally pressed CHAN again, in which case simply
press LEVEL then CLEAR.
In this mixer, soloing is what is known as “destructive” solo, in other words the
action of soloing something is actually turning everything else off on the mix bus,
so if you are recording the mix, you will hear the solo action.
It takes longer to describe these operations than it takes to do them, so a few
tries will make it clear.
PAGE SIX