Guardian Technologies GGU300 - Manual (Page 4)

6 7
Fig. 13 Fig. 14
Fig. 15
Handle
Removal
Button
Handle
Handle
Handle
Hose
Connector
Hose
Telescoping
Button
Handle
Hard Floor
Nozzle
CONVERTING TO CANISTER MODE (cont.)
Fig. 16
· Push handle removal button and pull up on handle to disconnect from body. (Fig. 13)
· Insert hose into handle hose connector and twist clockwise to lock in position. (Fig. 14)
· Push button on wand to extend telescoping wand. (Fig. 14)
· Insert end of handle into hard floor nozzle. (Fig. 15)
· Canister mode. (Fig. 16)
Base Safety
Switch
H Base
Handle
Release
Pedal B
USING IN UPRIGHT MODE
· Push the handle release pedal. (Fig. 9)
· Turn main power switch on. Turn brush power switch on.
Caution: The headlight and brush does not come on when in the upright position even if the
switch is on. You must release the handle for the brushroll to begin spinning. (Fig. 10)
Fig. 9
Fig. 11 Fig. 12
Hose
Base Hose
Connector
Base
Body
Release
Canister
Pedal
Canister
Handle
CONVERTING TO CANISTER MODE
· Remove hose from base hose connector. (Fig. 11)
· Step on release canister pedal and pull body upward by canister handle. (Fig. 12)
CONVERTING TO CANISTER MODE
Fig. 10
TOOL ASSEMBLY
· Attach crevice tool, dusting brush and upholstery
brush into storage area on the back of the vacuum. (Fig. 8)
Crevice
Tool
Dusting
Brush
Upholstery
Brush
Fig. 8
UPRIGHT MODE