Guardian Technologies AC6000 - Manual (Page 8)

E-14 E-15
TROUBLESHOOTING GUIDE
PROBLEM SOLUTION
Unit does not operate. Outlet: Make sure the electrical cord is plugged firmly
into the outlet.
Front Cover: Install the front cover properly.
Odors and smoke are not easily
being removed. Filters: Follow the installation directions carefully for each
filter. Clean or replace filters as needed.
Air Flow Openings: Make sure to keep objects away from
the air inlet and outlet openings.
The discharged air has an odor. Filters: Check to see if the charcoal and HEPA filters
need replacement.
Filter 'Check' remains on even
after a new HEPA filter has been
replaced. Filter Check 'Reset' Button: After changing the HEPA filter
make sure to trigger the Filter Check 'Reset' button with
a pin.
Remote Control does not work. Batteries: Replace the batteries with new ones.
Receiver: Is there an object blocking the receiver on the
main unit.
MAINTENANCE (cont.)
3. Open the sensor door.
4. Insert the cleaning pad into the dust sensor slot and clean the dust
sensor by moving the cleaning pad IN and OUT as illustrated.
G. UV Light Bulb
Do not wash the UV light bulb
with water.
Do not use detergent or chemicals of
any kind on the UV light bulb.
The UV light bulb is extremely fragile,
use caution when cleaning. A feather
duster is recommended.
The UV light bulb should only be replaced
by a qualified technician when needed.
AC6000_3L rev: Hygia 6.0 3L rev 8/30/07 1:50 PM Page 8