Haltech HT059980 - Manual (Page 14)

Figure 16 – Haltech WBC 2 Installation Diagram (Analogue Only)
Haltech CAN Wideband Controllers
(WBC 1 & WBC 2)
Quick Start Guide
Congratulations on purchasing a Haltech CAN Wideband Controller.
This Plug and Play product allows the user the ability to increase the functionality
of their Haltech ECU by using the Haltech CAN system which is fitted to all
Platinum Series ECU's.
The Haltech CAN Wideband Controller allows the user to accurately measure air/fuel
ratios over a wide range from rich to lean via the Haltech CAN system for precise
engine tuning.
This quick start guide will walk you through installation of the
Haltech CAN Wideband Controller (WBC1 or WBC2) into a vehicle.
This guide is accompanied by the full service manual located on the software CD
provided with the ECU that you or your tuner will need to refer to before completing
your installation and configuration.
Included in Haltech Single Channel CAN Wideband Kit (HT059976)
• Haltech Single Channel CAN Wideband Controller - WBC1
• Single Channel wiring harness
• CAN Connection Cable (600mm)
• 1 x Wideband Sensor – Bosch LSU 4.2
• 1 x Weldable fitting bung and blanking plug
• Quick Start Guide
Included in Haltech Dual Channel CAN Wideband Kit (HT059986)
• Haltech Dual Channel CAN Wideband Controller - WBC2
• Dual Channel wiring harness
• CAN Connection Cable (600mm)
• 2 x Wideband Sensor – Bosch LSU 4.2
• 2 x Weldable fitting bungs and blanking plugs
• Quick Start Guide