Haltech IG5 - Manual (Page 23)

19
The Install program will now run. Follow the instructions given. The program will suggest
that the software will be placed in the HALTECH directory. You can change the destination
directory, but this is not recommended unless you understand how directories work.
When it is finished, the installation program will tell you if the installation is successful. If it
was not, consult the trouble shooting section of this manual.
The IG5 Program is now ready to run.
2.2.3 Running the Software from the Hard Disk
Boot up your computer as described earlier. If your computer is already on, make sure the C
drive is currently selected. To change to the HALTECH directory type:
χ∆ ∴ηαλτεχη←
or, if you used a different destination directory, type that path.
To start the program type:
ιγ5←
The IG5 program will now run. The next section is on running the software from a floppy
drive. If you intend to run the program from the hard drive you can skip this section and go
straight to the section entitled Azerty Keyboards.
2.2.4 Running the Software from the Floppy Disk.
To run the software from a floppy drive, boot up your computer as described earlier. Insert
the Programming disk in the disk drive. To select the appropriate disk drive (this will most
probably be A: or B:) type:
α:←
or
Β:←
You should now see the prompt :
A:\>_
or B:\>_
To start the IG5 program type :
ΙΓ5←
The IG5 program will now run.