Haltech E6S - Manual (Page 13)

13
•
Engine Speed Pickup
Compatible with most trigger systems:
- 5 or 12 volt square wave;
- pull-to-ground (open collector)
Tach adaptor available for magnetic (or ‘reluctor’) triggers
ECU Outputs
•
Injector Driver
E6S
4 x 4/1 Amp peak-and-hold current limiting drivers:
- up to four low-impedance injectors*
- up to eight high-impedance injectors*
(Expandable using optional Driver Box. See Appendix C)
E6S - 8
8 x 4/1Amp peak-and-hold current limiting drivers:
- up to eight low-impedance injectors*
- up to sixteen high-impedance injectors*
(Expandable using optional Driver Box. See Appendix C)
•
Ignition Output
Haltech Ignition Module, trigger by ECU, for directly firing the coil.
(may also be compatible with other igniters. Ask your Haltech dealer.)
•
Fuel Pump Control
20A fused relay, features automatic priming and switch-off.
* additional hardware may be required
System Programming Requirements
•
Computer
IBM-PC or compatible, preferably laptop or notebooks
CGA, EGA or VGA, colour or monochrome display
640+ kb RAM
•
Disk Drive
3.5" Floppy Disk Drive
(5.25" disk available on request)
•
Serial Port
Standard RS232C port - 9 pin D connector
(25 pin cable available on request)
COM1 or COM2 (selectable)