HONDA 2015 Accord Hybrid - Owner's Manual - Manual (Page 493)

492
uu Replacing Light Bulbs u Brake/Taillight, Rear Turn Signal Light, and Rear Side Marker Light Bulbs
Main
tenan
ce
Brake/Taillight, Rear Turn Signal Light, and Rear Side
Marker Light Bulbs
When replacing, use the following bulbs.
1. Remove the holding clips using a flat-tip
screwdriver, then pull the lining back.
2. Turn the socket to the left and remove it.
3. Remove the old bulb and insert a new bulb.
Brake/Taillight: LED
Rear Turn Signal Light: 21 W (Amber)
Rear Side Marker Light: LED
1 Brake/Taillight, Rear Turn Signal Light, and Rear Side Marker
Light Bulbs
Brake/taillight and rear side marker light bulbs are
LED type. Have an authorized Honda dealer inspect
and replace the light assembly.
When removing the clip, insert a flat-tip screwdriver,
then lift and remove the clip.
Insert the clip with the pin raised, and push until it is
flat.
Clip
Push until the
pin is flat.
Holding Clip
Bulb Socket
15 ACCORD FHEV-31T3W6100.book 492 ページ ２０１４年７月２３日 水曜日 午後３時１０分