HONDA 2015 Civic Hybrid - Owner's Guide User Manual

Page 13

Advertising
background image

18 |

| 19

SAFETY

SAFETY

Installing a Child Seat with a Lap/Shoulder Seat Belt

1. Place the child seat on the vehicle seat.

2. Route the seat belt through the child seat

according to the seat maker’s instructions, and
insert the latch plate into the buckle. Insert the
latch plate fully until it clicks.

3. Slowly pull the shoulder part of the belt all the

way out until it stops. This activates the lockable
retractor.

4. Let the seat belt completely wind up into the

retractor, then try to pull it out to make sure the
retractor is locked. If you are able to pull the
shoulder belt out, the lockable retractor is not
activated. Pull the seat belt all the way out, and
repeat steps 3 – 4.

5. Grab the shoulder part of the seat belt near the

buckle, and pull up to remove any slack from
the lap part of the belt. When doing this, place
your weight on the child seat and push it into the
vehicle seat.

6. Make sure the child seat is fi rmly secured by

rocking it forward and back and side to side; little
movement should be felt.

7. Make sure any unused seat belt that a child

can reach is buckled, the lockable retractor
is activated, and the belt is fully retracted and
locked.

To deactivate a lockable retractor, release the buckle and allow the seat belt to
wind up all the way.

Adding Security with a Tether

A tether anchorage point is provided behind each rear seating position.
Regardless of whether it is installed with LATCH or a seat belt, a child seat that
comes with a tether should use the tether for additional security.

1. Locate the appropriate tether anchorage point

and lift the cover.

2. Raise the head restraint to its highest position,

then route the tether strap through the head
restraint legs. Make sure the strap is not twisted.

3. Secure the tether strap hook onto the anchor.

4. Tighten the tether strap according to the seat

maker’s instructions.

Tether anchorage points

Anchor

Outer position

Center position

Anchor

Anchor

Cover

Tether
strap hook

Tether
strap hook

Advertising