Centro 85-1095-6 - Manual (Page 12)

1 0
T R O U B L E S H O O T I N G G U I D E
Corrective Action
• Clean out blockage
• Open cylinder or gas supply valve
• Ensure proper Venturi assembly
• Clean / replace burner
• Refill cylinder
• Follow correct lighting procedure,
and perform leak test
• Tighten regulator fully (hand tighten) onto cylinder
• Straighten fuel hose
• Clean out blockage
• Clean burner
• Open air shutter
• Check all connections are tight
• Ensure collector box, burner and
ignitor are assembled properly
• Replace ignitor
• Relocate barbecue back towards wind
• Refill cylinder
• Trim meat, turn down burner controls
and / or fuel supply
• Clean casting base and burner
• Position cooking system correctly
• Immediately shut off gas at source,
allow grill to cool and clean out Venturi tubes
• Temporary condition caused by high outside
temperatures and a full propane cylinder
• Clean / replace burner
Possible Causes
• Blocked Venturi tubes
• Cylinder or gas supply valve turned off
• Venturi tubes not properly sealed over orifices
• Burner ports blocked
• Low or out of propane
• Flow control device activated
• Regulator not fully tightened into cylinder
• Partially blocked Venturi tubes
• Excess cooking salts on burner
• Air shutter closed
(side and rear rotisserie burner only)
• Loose wire connection
• Broken electrode ceramic
• Poor ground
• Faulty ignitor
• High wind conditions
• Propane low
• Excessive fat in meat
• Grease drain plugged
• Cooking system not positioned correctly
• Blocked Venturi tubes
• This is not a defect or a hazard
• Plugged, rusted or leaking burner
Problem
Burner will not light
(match or ignitor)
Burners not hot enough
Flames smoky yellow
Burner lights with match
but not with ignitor
Flame blows out / down
through base
Too much heat / excessive
flare-up
Flames under heat
control console
Regulator humming
Incomplete flame
For more troubleshooting support or parts ordering please call toll free 1-877-707-5463.