HONDA 2008 Civic Hybrid - Owner's Manual - Manual (Page 227)

If you replaced a headlight bulb on
the driver’s side, reinstall the
engine coolant reserve tank.
To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, then turn off the engine. To
change the bulb on the passenger’s
side, turn the steering wheel to the
left.
Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
Remove the bulb from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Install the new bulb, and turn it
one-quarter turn clockwise to lock
it in place.
Turn on the headlights to test the
new bulb.
Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
2.
3.
2.
4.
5.
6.
7.
1.
Low Beam Headlight
Lights
224
TAB
HOLDING CLIP
CONNECTOR
BULB
2008 Civic Hybrid
Table Of Contents Main Menu