Transmission fluid – HONDA 2007 Civic Sedan - Owner's Manual User Manual

Page 235

Advertising
background image

Check the fluid level with the engine

at normal operating temperature.

If the level is below the lower

mark, add fluid into the dipstick

hole to bring it to the level

between the upper and lower

marks.

Park the vehicle on level ground.

Run the engine until the radiator

fan comes on once, and then goes

off. Turn off the engine. For

Always use Honda ATF-Z1
(automatic transmission fluid). If
it’s not available, you may use a
DEXRON III automatic
transmission fluid as a temporary
replacement. However, continued
use can affect the shift quality.
Have the transmission flushed and
refilled with Honda ATF-Z1 by
your dealer as soon as it is
convenient.

Remove the dipstick and check
the fluid level. It should be
between the upper and lower
marks.

Insert the dipstick all the way into
the transmission securely as
shown in the illustration.

Remove the dipstick (yellow loop)
from the transmission, and wipe it
with a clean cloth.

Pour the fluid slowly and carefully
so you do not spill any. Clean up
any spills immediately; it could
damage components in the engine
compartment.

3.

4.

5.

1.

2.

Transmission Fluid

Automatic Transmission

232

DIPSTICK

UPPER
MARK
LOWER
MARK

accurate results, wait about 60

seconds before going to step 2, but

don’t wait longer than 90 seconds.

Main Menu

Table of Contents

Advertising