HONDA 2007 S2000 - Owner's Manual - Manual (Page 179)

Unscrew the wing bolt, and take
the spare tire out of the spare tire
shelf. Remove the three clips holding
the spare tire cover by pulling the
rings straight back. Remove the
spare tire cover.
Loosen each wheel nut 1/2 turn
with the wheel nut wrench.
Place the jack under the jacking
point nearest the tire you need to
change. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the center of the jacking
point tab is resting in the jack
notch. 4. 5.
6.
7.
Changing a Flat Tire
176
SPARE TIRE COVER WHEEL NUT WRENCH
JACKING
POINT
CLIPS
Main Menu Table of Contents