Warning, Using the reclining backrest, Attaching & using the wheels – Combi 9810 User Manual

Page 4: Using and adjusting the 5-point harness

Advertising
background image

- 4 -

• Use the high chair with the backrest in the full recline

position to carry 2-3 month old babies without a strong
neck.

• The backrest can be adjusted to 5 positions.
• The footrest angle changes along with the recline.

1. To recline the backrest, pull and hold the reclining lock

lever
located on the back of the seat.

2. After the recline position is determined, always lock the

reclining lock lever by releasing it to its original position.

To return the backrest to
the upright position,
pull and
hold the reclining lock lever
and push the seat forward.
The seat will lock into place
again by releasing the reclining
lock lever.

Using the Reclining Backrest

CAUTION

Always adjust the harness when
changing the reclining angle.

Always keep the reclining lock
lever in the lock position.

Be careful that there are no
obstacles in front of it before
using since the footrest will move
during the recline.

Attaching & Using the Wheels

To lock wheels, lower the brake

lever. (Down position.)

To unlock wheels, lift the brake

lever. (Up position.)

CAUTION

Even when the har-
ness is fastened, be
careful not to let
the child slip out or
stand.

CAUTION

Always keep the wheels locked other
than when moving the high chair. Failure
to do so may cause the high chair to
move unexpectedly.

Wheels must be locked when using the
glide feature.

1. Place the crotch belt between the

child's legs.

2. Insert both waist belt buckles into the

middle
plastic piece.

3. Attach each shoulder

strap hooks to the top of
the waist belt clips.

4. To adjust the harness or

waist belt, loosen the
slack on both sides of
each buckle.

Using and Adjusting the 5-Point Harness

WARNING

Avoid serious injury
from falling or sliding
out. Always use har-
ness for security.

Reclining Lock
Lever

Brake Lever

1

2

3

4

5

Full
upright

Full
recline

Front Swivel Wheels
Insert the swivel wheels, with the circular shaft,
into the circular hole in the base of the front
legs.

Rear Stationary Wheels
Insert the rear wheels, with the square shaft,
into the square hole in the base of the rear legs.

Advertising
This manual is related to the following products: