ILY CFast/HDD Duplicator - Manual (Page 14)

SATA HDD Duplicate Controller Manual
3.10.11 Tolerance Size
This option is used to do to ensure that when the target is smaller than the source can not be
performed when the copy.
10-11. Setup
Tolerance Size
Press ENT to enter the following figure. The default is Off. Use the Up and Down arrow keys to
choose 1%~100% of source.
Tolerance Size
1% ( 4.7GB)
3.10.12 BootTime Delay
This option is used to to set boot delay time.
10-12. Setup
BootTime Delay
Press ENT to enter the following figure. The default is 5 sec. Use the Up and Down arrow keys to
choose 0~99 sec.
BootTime Delay
5 sec
13
3.10.13 Quick Compare
This option is used to set the size of each comparison unit.
10-13. Setup
Quick Compare
Press ENT to enter the following figure. The default is Off. Use the Up and Down arrow keys to
choose 1 Byte/1K/10K/100K/1MB/10MB/100 Mbytes. (In order to improve the accuracy of pure
data can maintain the default settings.)
Quick Compare
Off
3.10.14 Copy with Size
This option is used to set the source hard disk with the target hard disk the same capacity after a
copy operation.
10-13. Setup
Copy with Size
(for 1-1 Duplicator Only)