ILY USB Mini Portable USB Duplicator - Manual (Page 8)

viruses. It can only check to see if the virus is present, but cannot clean or eliminate the virus.
Show Flash device’s USB virus Steps:
1. Insert Flash devices into duplicatorÆSelect [4. Utility ]ÆPress [OK]ÆSelect [4.2 Chk USB
Virus ]ÆPress [OK]ÆSystem will search for USB Viruses
When red LED is on, it means the system found a potential risk of a USB Auto run virus.
2. Press [Forward]/[Backward] to check other Flash devices’ for virusesÆ Press [ESC] to finish
4.3 Capacity Check
This function checks Flash device’s real capacity and checks to ensure that the Flash devices work.
Check Flash device’s real capacity Steps:
1. Insert Flash devices into duplicatorÆSelect [4. Utility ]ÆPress [OK]ÆSelect [4.3 Capacity
Check]ÆPress [OK]ÆSystem analyzes the Flash device’s real capacity
2. Press [Forward]/[Backward] to check other Flash devices’ real capacityÆ Press [ESC] to finish
**Capacity check function supports asynchronous operation; you can plug in and pull out Flash devices
to check their real capacity continuously without pressing any other buttons.
4.4 Format FAT
This function formats Flash devices. The system will automatically format the Flash device according
to its capacity. If the Flash devices capacity is above 2GB, the system will format the Flash device to
FAT32, if the Flash devices capacity is below 2GB, the format will be FAT16. During the format process,
you can check each Flash device’s formatting status by pressing [Backward]/ [Forward].
**The source (master) port (port #1) does not execute format function.
Formatting Flash device Steps: