Interlogix MC355-1T/1S Installation Guide - Manual (Page 8)

2 IFS MC355-1T/1S Quick Installation Guide
Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of
Industrial Managed Media Converter is used for two DC
redundant power supply inputs. Please follow the steps below
to insert the power wires.
1. Insert the positive / negative DC power wires into the
contacts 1 and 2 for POWER 1, or 5 and 6 for POWER 2.
Figure 1 shows PWR1 and PWR2 of the Industrial
Managed Media Converter.
Figure 1: PWR1 & PWR2 of Industrial Managed Media Converter
V1- V1+ V2- V2+
2. Tighten the wire-clamp screws to prevent the wires from
disconnecting. Figure 2 shows PWR1 and PWR2 pin of the
terminal block.