Interlogix POE302-EX - Manual (Page 9)

IFS POE302-EX User Manual
9
Hardware Installation
This product provides three different running speeds – 10Mbps, 100Mbps and 1000Mbps in the same device and automatically
distinguishes the speed of incoming connection.
This section describes the hardware features of POE302-EX. Before connecting any network device to the POE302-EX, read
this chapter carefully.
3.1 Before Installation
Before your installation, it is recommended to check your network environment. If there is any far away IEEE 802.3at / 802.3af
devices need to power on, the POE302-EX can provide you a way to supply power for this Ethernet device conveniently and
easily.
The POE302-EX is installed between the PSE (Power Source Equipment) and the PD (Powered Device); it is powered by PSE
and forwards the Ethernet data and remaining POE power to the PD. The POE302-EX doesn’t require an external power
supply and it can be installed easily just plug and play; that means the operator does not need to configure the POE302-EX.
The POE302-EX injects power to the PDs without affecting the data transmission performance. It offers a cost effective and
quick solution to extend power and data an additional 100m.
1. To provide you better PoE power and data extension quality, we strongly recommend that you use
“Solid UTP Cable” when installing POE302-EX.
2. The POE302-EX can be installed with third-party device if the device complied with IEEE 802.3at /
802.3af standard.
3.2 Connect POE302-EX to the Power Source Equipment (PSE)
There are 2 RJ-45 ports in the PoE Extender, of which the “IN” port functions as "PoE (Data and Power) input" and
the ”OUT” port on the other side functions as "PoE (Data and Power) output".
Step 1: Connect a standard Cat.5/5e/6 UTP cable from Power Source Equipment (PSE), such as PoE Switch, PoE Injector
hub and single port PoE injector, to the “IN” port of POE302-EX.
Step 2: The PSE delivers both Ethernet Data and PoE power over UTP cable to the POE302-EX and the “PoE IN” LED will be
steady on.
1. The POE IN LED turn on steady green means POE302-EX is being powered successfully with PoE
class 0.
2. If POE IN LED does not turn on, please check the remote PSE or the cable with a PC or a network
device to see if the cable is correct. Or with an IEEE 802.3at / 802.3af device such as the target PD to
check the power injection is correct either.