Cabletron Systems Environmental Module TM 9C300-1 - Manual (Page 31)

3-19
Interactive Mode
The Module Specific Screen
Select a module on the Module Selection Screen, as shown in Figure 3-23, to
display configuration information on the Module Specific Screen, as shown in
Figure 3-24.
Line 1 identifies the selected module by chassis slot location, current status, and
hardware revision. A module’s status can be one of the following:
ON-LINE The host processor is operational.
DOWN The host processor is not operational.
FAULT The power-up diagnostic tests have failed.
Lines 2 and 3 display a firmware revision and SMB-1 firmware revision, along
with the BOOT PROM revision and the module serial number.
Line 4 lists the following three submenus. Access a specific submenu by selecting
it on the screen.
<ENV> accesses the Module Environment Screen, showing
environmental parameters for the selected module.
<MEMORY> accesses the Module Memory Screen, showing the amount of
various memory categories on the module.
<BACKPLANE> accesses the Module Backplane Screen, showing backplane
configuration parameters.
Figure 3-24. The Module Specific Screen
Select <EXIT> to return to the Module Selection Screen.
FW REV x.xx.xx SMB 1 FW REV x.xx.xx
<ENV> <MEMORY> <BACKPLANE> <EXIT>
MODULE xx STATUS ON-LINE HW REV xxx
BOOT PROM REV x.xx.xx SN xxxxxxxxxxxx