Interlogix 60-880-95 - Manual

1
6HQWURO,7, $3:
:LUHOHVV 3,5 0RWLRQ
6HQVRU
ITI Part No. 60-880-95
Installation Instructions
Document Number: 466-1851 Rev. B
July 2001
Product Summary
A motion sensor (passive-infrared or PIR) detects move-
ment by sensing the infrared energy emitted from a body as
it moves across its field of view. When this motion is
detected, the sensor transmits an alarm signal.
Install motion sensors to protect areas where door/window
sensors are impractical or not needed. For example, use a
motion sensor to protect large areas or open floor plans.
Motion sensors can also provide backup protection in areas
where door/window sensors exist.
This wireless motion sensor includes the following features:
‰ Field-selectable coverage area; 33 or 50 feet
‰ Field-selectable sensitivity modes; 2-pulse or 4-pulse
‰ 135-second transmitter lockout time after an alarm that
helps extend battery life
‰ Cover-activated tamper
‰ Supervisory signal transmitted every 64 minutes to the
control panel
‰ Sensor low battery reports (trouble) to the control panel
Included with the sensor is a thin cardboard undercrawl
mask and snap-in plastic masks (installed at the factory).
Self-adhesive masking strips are also included.
Installation Guidelines
‰ If possible, locate sensors within 100 feet of the panel.
While a transmitter may have an open-air range of 500
feet or more, the installation site can have a significant
effect on transmitter range. Changing the sensor loca-
tion may help overcome adverse wireless conditions.
‰ Mount the sensor permanently on a flat wall or in a cor-
ner. Do not set it on a shelf.
‰ For installations without pets, the required mounting
height is 7 1/2 feet.
‰ Mount the motion sensor on an insulated, outside wall
facing in.
‰ Mount the motion sensor on a rigid surface which is
free from vibrations.
‰ Position the sensor so it faces a solid reference point,
like a wall.
‰ Do not aim the sensor at windows, fireplaces, air condi-
tioners, heaters/heating vents, or place it in direct sun-
light.
‰ Position the sensor to protect an area where intruders
are most likely to walk across the detection pattern (see
Figure 1).
Figure 1. Overhead View of Detection Pattern
‰ Do not mount the sensor near duct work or other large
metallic surfaces which may affect the RF signals (see
“Final Testing” on page 4). Actual acceptable transmit-
ter range should be verified for each installation.
‰ Windows should be closed in any area which has an
armed motion sensor.
‰ The cardboard undercrawl mask installed at the factory
(see Figure 2) blocks coverage within 5 feet of the sen-
sor.
Figure 2. Cardboard Undercrawl Mask Location
1RWH
The cardboard undercrawl mask should remain
installed when sensor jumper J1 is set to the BI posi-
tion. See the section “Setting the Sensor Coverage
Area and Sensitivity” for complete information on sen-
sor jumper settings.
8362G04B.DS4
Person walking across detection path