Interlogix TruVision 360° Instructions to remove cover - Manual

P/N 1072855B • REV 1.0 • ISS 26SEP14
© 2014 United Technologies Corporation. Interlogix is part of UTC Building & Industrial Systems, a unit of
United Technologies Corporation. All rights reserved.
Instructions to remove the TruVision
360° camera cover
To remove the Truvision 360°
camera cover
1. Open the small flap on the camera
cover. Using the hex wrench provided,
loosen the small screw.
2. Two clips on the cover ring lock it on to
the camera base.
Using a flathead screwdriver, release the
two clips on the base of the camera to
detach the cover.
3. Grasp the opening on the side of the
cover (1), and pull the cover and base
apart to open the camera.
A.
B.
C.
Note: When the TruVision 360° camera is
mounted to the wall or ceiling, you will not
have access to the two clips. In such
situations, use a flathead screwdriver to
gently pry the cover (see step 3 A.1) apart
from the camera base.