Interlogix NVR 20 User Manual - Manual (Page 112)

106 TruVision NVR 20 User Manual
Note: When adding a device to the Network Video Surveillance software, the
multicast address must be the same as the DVR’s multicast IP.
Device Port & HTTP Settings
Unless your IT Manager has a specific requirement to use specific ports across
the network, the recommendation is to keep the default settings. Both settings
are on the same page.
If you are using video software (Interlogix’s TruVision Navigator), if you change
either of these two settings, TruVision Navigator software needs to have these
changes reflected in the device setup within TruVision Navigator.
Device Port Used by Interlogix’s TruVision Navigator Software and Remote Client
Software and has a available address range from 2000-65535.
Default Setting is 8000.
HTTP Port Used by Remote Client Browser to access the TVN 20 Browser
across the network. Default Setting is 80.
To view or change these settings:
1. Navigate to the Network Settings page from Main Browser Page: Click
Config > under Remote Config area, select Configuration parameters and
then under Network Parameters select the Network Settings option in the
Navigation window.
2. Enter the desired values for these two settings
3. Click Save to retain these settings