Interlogix NVR 21 (S/P) Quick Start - Manual (Page 6)

EN : 6 TVN 21(S/P) Quick Start Guide
1. Connect all the devices required to the
back panel of the recorder . See Figure 1
on page 3.
Basic connections:
Connect monitor A to the BNC, VGA or
HDMI output. Connect the mouse to the
USB port in the front panel.
Optional connections:
All the other connections shown are
optional and depend upon installation
requirements.
2. Connect the power cord to the unit and
turn on the power.
3. Set up the unit with the required
settings using the setup wizard.
First-time use
The recorder has an express installation
wizard that lets you easily configure basic
recorder settings when first used. It
configures all cameras simultaneously. The
configuration can then be customized as
required.
By default, the setup wizard will start once
the recorder has loaded. The wizard walks
you through some of the more important
settings of your recorder . Select the
preferred language for the system and then
enter the administrator password. The
default admin password is 1234. It is
strongly recommended that this password is
changed.
The wizard will then guide you through the
menus to set the time and date, network
configuration, HDD management, and
recording configuration.
When all the required changes have been
entered, click Finish to exit the wizard. The
recorder is now ready to use. Recording
starts automatically.
Operating the TVN 21
There are several ways to control the unit:
• Front panel
• IR remote control
• Mouse
• Web browser
Front panel
The buttons on the front panel control most
functions. See Figure 2 on page 4 for the
locations of the controls. Refer to the user
manual for a detailed description of the
button functions.
IR remote control
The IR remote control buttons are similar to
those on the front panel. Place the two AAA
batteries in the remote control.
To connect the remote control to the
recorder , press the Device button, enter the
device address, and press Enter.
To connect the remote control to the
recorder:
1. Press Menu on the front panel or right-
click the mouse and select Menu . The
main menu screen appears.
2. Select Display Mode Settings >
Monitor .
3. Check and remember the recorder
device address value. The default value
is 255. The device address is valid for
all IR controls.
4. On the remote control, press the
Device button.
5. Enter the device address value. It must
be the same as that on the TVN 21.
6. Press ENTER on the remote or front
panel.
USB mouse
The USB mouse provided with the recorder
operates all the functions of the recorder ,
unlike the front panel, which has limited
functionality. The mouse lets you navigate
and make changes to settings in the user
interface.
Connect the mouse to the
recorder by
plugging the mouse USB connector into the
USB port on the front panel. The mouse is
immediately operational and the pointer
should appear.