Configure a camera – Interlogix TruVision Navigator 5.0 User Manual User Manual
Page 70
Chapter 3: Operation
62
TruVision Navigator 5.0 Service Pack 3 User Manual
Configure a camera
The steps required to modify a camera’s configuration is similar to that of configuring a
device. To change a specific camera’s configuration do the following:
Right-click on a camera in the Navigator and select Configure Camera. A configuration
dialog will open.
Navigate through the settings, make changes as appropriate, and either click Ok or
Cancel.
Ok will save the settings to the device and Cancel will abort the configurations you
made.
Note:
The trusted source for camera titles is the device itself. When adding a device for
the first time, TruVision Navigator will not pull the device’s configuration information at
the time of connection. Therefore, the cameras under the device in the Navigator panel
may display generic camera titles (Camera 1, Camera 2, Camera 3, etc.). Camera titles
are updated in TruVision Navigator after you pull the device configuration for the first
time. Afterwards, any changes to camera titles through TruVision Navigator will update
both the Navigator and the device.
Note:
For protocol configuration of analog PTZ cameras attached to an embedded NVR
via an encoder, please use encoder web administration rather than the embedded
recorder configuration menu.