ISP Technologies Tripower 900 User Manual
Page 3
PLACEMENT
The Tripower 900 is designed to sit on the floor or stage. Do not position or mount the
cabinet where it can tip over and fall on someone. Do not attempt to mount the cabinet on
speaker stands. Do not attempt to ‘fly’ (suspend by cables, chains, ropes, etc.) the cabinet.
It was not designed for flying. Position it only on a flat, stable surface where it is not in
danger of tipping over.
Also note that the placement of the cabinet relative to floors and walls will affect the low
frequency response (below about 500 Hz.). Placing it closer to the floor and walls will
reinforce the low frequency response. The closer it is, the higher in frequency this
reinforcement will go. Also make sure that adequate space (at least 6 inches) is left behind
the cabinet for air flow over the amplifier heatsink.
REAR PANEL DESCRIPTION
1. POWER SWITCH-This switch provides power to the Tri-Power power amp section. This
switch is a three-position switch where center is OFF and the outer positions are ON.
2. POWER INLET MODULE-This module provides a connection for the power cord and also
houses the mains fuse. (See Fuse Replacement Section)
3. INPUT GAIN- This control determines the overall input level of the signal to the power
amp section of the Tri-Power cabinet. Adjusting this level will not affect the level of the
signal passing through to output connectors.