Philips HP6376/00 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Shaving With Micro Shaver

Use the micro shaver to shave along contoured edges to remove any

stubble while creating a smooth, well-defined bikini line.

► Before using the micro shaver, always check it for wear and damage.

If the micro shaver shows signs of wear or damage, do not use it as

injury may occur. Do not use the micro shaver attachment until it
has been replaced.

D Pre-trim the contours desired with the precision trimmer

without a comb.

Q Remove the precision trimmer from handle (fig. 12).

Q Put the micro shaver on the handle.

Q Remove the protective cap (fig. 13).

H Switch the trimmer ON.

Q Gently press the micro shaver onto the skin and shave against

the direction of hair growth along contoured edges to remove
any stubble (fig. 14). Do not press too hard.

Cleaning

I The trimmer should be cleaned after each use.
I Always switch trimmer OFF, unplug and remove power supply cord

from trimmer before cleaning.

I Do not use abrasive cleaning agents, scourers or liquids such as

alcohol, benzene, bleach or acetone to clean the trimmer and
attachments.

I Never clean, replace or remove attachments with motor ON.
I Do not apply pressure to cutters.
► Do not touch cutters with hard objects as this may damage them.

During Use:

I If cut hairs have accumulated in the attachments, remove hairs by

shaking, blowing or using cleaning brush provided. Remember to

adjust the hair length selector back to your selected setting when

you replace the precision comb on the trimmer.

After Each Use:

D Make sure the trimmer is switched OFF and disconnected from

the electrical outlet.

Q Remove any attachment from trimmer.

Q Blow and/or shake out any hair that may have accumulated in

the attachment.

Q To clean the micro shaver, pull the foil in the direction of the

arrow to remove from base of micro shaver (fig. 15).

H Clean the cutter and the inside of the shaving foil carefully with

the brush or under warm tap water.

Do not use a towel to dry the micro shaver as damage to the shaving

foil could occur

I The shaving foil is very delicate. Handle carefully.
ft If foil becomes damaged, do not continue using the appliance.
ft Do not clean the foil with the brush, as this may cause damage.

Q Rinse attachments thoroughly under warm tap water.

Q Shake excess water from attachment and allow to dry thoroughly.

Q

Place the attachment back on the handle.

This trimmer has no other user-serviceable parts. For assistance,

call 1-800-243-7884.

Storage

ft Be sure trimmer is turned OFF. Remove cord from outlet and

trimmer before storing in a safe, dry location where it will not be

crushed, banged, or subject to damage,

ft Do not wrap cord around trimmer when storing,
ft Store cord in a safe location where it will not be cut or damaged,
ft Do not place or store trimmer where it can fall or be pulled into a

tub or sink, water or other liquid while plugged in.

Assistance

For assistance, call toll free:

1-800-243-7884

or visit our website:

www.philips.com/support

Information is available 24 hours a day, 7 days a week.

Advertising
This manual is related to the following products: