Cleveland Range HA-MKGL-80 - Manual (Page 34)

NEW SCRAPER BLADE
INSTALLATION PROCEDURE
Fig. 2 Fig. 3 Fig. 1
Scraper
blade
Back stop
Move to
adjust
Move to
adjust
Trim corners or
center to fit
Spring
QUAD RING REPLACEMENT
PROCEDURE
1. Remove agitator as per cleaning instructions.
2. Remove hole cap, retaining bolt and retaining
washer.
3. Snap retaining ring out from seating inside motor.
4. Remove retaining knobs.
5. Slide seal retainer plate away from kettle.
6. Slide shaft away from kettle body to allow
clearance for removing quad ring.
7. Remove quad ring.
8. Slide new quad ring back into original position,
making sure it does not twist.
9. Apply light coat of food-safe grease.
10. Slide retainer plate back toward kettle, replacing
retaining knobs -tighten with hand pressure only.
11. Reassemble.
Retaining ring
Hole cap
Retaining bolt
Retaining washer
Retaining
ring seat
Quad ring
Seal retainer plate
Retaining knobs
AIR FILTER REPLACEMENT
PROCEDURE
1 Disconnect air supply and bleed system.
2. Remove cover on console (see SIDE BOX -
PNEUMATICS).
3. Check for filter location.
4. Push lever down
and rotate bowl/
guard assembly
1/8 turn.
5. Push down on
bowl/guard
assembly
and remove.
6. Unscrew baffle
and remove filter
element, inspect
and replace filter
if required.
7. Replace filler cap
and cover.
Deflector
Filter
Element
Baffle
Lever
Bowl/Guard
Assembly
LUBRICATION PROCEDURE
Lubricate the following parts every three months to
insure smooth operation and reduce wear.
TRUNNION
HOUSING,
WORM SCREW
AND TILT GEAR
These parts are
accessed through the
top cover of the
console.
Apply grease to gear
teeth. Check for
excessive play and adjust with adjusting screw located
on top of cross bar.
KETTLE
TRUNNIONS
On the left hand side of
the kettle there are two
grease nipples on the
top back portion of the
trunnion housing. On the
right hand side of the
kettle you must remove
the console cover to
access the two grease
nipples.
Trunnion Housing
Grease Nipple
Adjusting
Screw
Worm
Screw and
Tilt
Gear
Cross
Bar