Philips g380 - Manual (Page 8)

I If you are trimming for the first time, start by
using the AccuControl comb at the maximum
trimming length setting (#9) to prevent
accidentally trimming hairs too short-As you
become Umiliar with the settings, adjust Hair
Length Selector to desired trimming length.
Selector will "click" into position at each
setting.
a Switch the Groomer ON.
□ To trim in the most effective way. move
the Groomer against the direction of hair
growth. Make sure the sur^ce of the Guide
Comb always stays in contact with the skin
(fig-8).
NOTE Since .ill h.jii s do not ^to.v in the scìnte
d<roa!c.n.-,ou nuv svjni 10 It. d-fferenl tnmming
directions (i.e.. upwards, downwards, or across).
Practice ts best for optimum results.
I If a lot of hair has accumulated in the Guide
Comb, remove the comb and blow and/or
shake the hair out of the comb. You can also
use the cleaning brush provided to remove
hair from the comb area.
> REMEMBER:You must reset the hair length
selector back to your desired setting every
time you replace the guide comb on the
appliance.
Table 1. Beard Trimmer
Si
tting Remaining hair length
<in.)/(mm)
1 Stubble .06 n^2mm
Cbsdy Crapped .16 W‘lmm
3 Short .2^ <V6nvn
K.
Medium Short Jl «VSnvn )
5 Medium 39 n/iOmm
É
MedumLcog Al ir/l2mm
7 Long 55 »n/i4mm
i.
Extra Long 63 tn/l6mm
9 Longest 71 in/16mm
I The remaining hair length corresponds with
the smallest distance between the cutting blade
and the spot where the comb is in contact
with the skin.
I Cutting wi^out the comb attachment or
seuing the AccuControl guide comb to
U \
position will result in a stubble beard look.