Philips VR454 - Manual (Page 9)

Set the Clock 9
T o set your VCR to the present day and time, follow steps 1-4 below. Once set, your VCR (Video Cassette Recorder)
will maintain the time in its internal clock, and will make timer recording possible.
TVPO’^R
CD
VCRPOWER
CD
CDACD CD CDA
(VCRCK) GäHEcH) Go-To t S
CD y CD CD CD t
CD CD O Ö
CD CD CD CD
CD CD CD CD
<VAR SLOW ■
aiz:
VAR SLOW>
IDD
■^►/TRACKiNQ —
u 1 Z] D
FAD7 IISTiU. SLOW
CD
1_
_l (ZD
(EtS) OTR MEMO X2PIAY
(ZD (ZD (ZD (ZD
SPEED CLEAR STATUS TV,VCR
IZD
CD
CD- ! t—
PHILIPS
REMOTE CONTROL
MENU
Button
NUMBER
Buttons
STATUS
Button
CLEAR
Button
Remote Control
I Make sure... I-----------------------------------------------------
• your VCR and TV are connected and turned on.
• the VCR indicator says “VCR”.
• to make each entry within 10 seconds, otherwise the VCR will exit
the Clock Set mode and you will have to start over.
Select the Clock Set Mode
Press the MENU button. Then press the 5
button to select “CLOCK SET” from the
menu screen.
Set the Time & AM or PM
First, press two NUMBER buttons for the hour, then two NUMBER
' buttons for the minutes, and finally press “1” for AM or “2” for PM.
For example, for 10:30 PM, press the NUMBER buttons 1-0,3-0,2.
When setting the clock for the first time, entries that do not
match the VCR’s internal calendar will cause a “?” to appear.
Always enter “0” before any single-number entries.
To make corrections, press the CLEAR button repeatedly to move
back to an item then enter the correct number.
Set the Month, Day & Year
Press two numbers for the month, two
numbers for the day, and two numbers for
the year.
For example, for July 1,1994, press the
NUMBER buttons 0-7,0-1,9-4.
TIME 10 30 PM
TO CORRECT PUSH CLEAR
TO END PUSH MENU_______
Start the. Clock
TIME 10 30 PM
DATE07i0L94
FRI
TO CORRECT PUSH CLEAR
TO END PUSH MENU
1
Press the MENU button.
Clock starts and the screen returns to the program you were on.
To display the time, press the STATUS button.
To Reset the Clock
Press the MENU button. The TV and VCR must be on and the VCR
in the “VCR” mode. The menu screen will appear. Press the
NUMBER 5 button and follow the clock set
guide to re-enter the new date and time. TO SELECT PUSH NO SHOWN
1 PROGRAM
2 VCR SET UP
3 TUNER SETUP
4 INPUT SELECT
5 CLOCK SET
6 DAYLIGHT SAV TIME
. TO END PUSH MENU
Power failures can cause you to lose your clock setting placed in the
VCR’s memory. Should this happen, repeat steps on pages 8 and 9
before doing anything else.
Your VCR should now be properly set-up.
Go to the next page and try playing a tape.