Philips D6668 - Manual (Page 4)

English
RECHARGEABLE BATTERIES
• This cassette player is provided with two rechargeable
Nickel-Cadmium batteries, type R6, UM3 or AA.
• Charge the batteries prior to first use and also if the
player has not been used for a long period.
• After 8 hours of charging, the batteries will be fully
charged and will last about 4 hours in the PLAY mode. As
soon as the POWER ON indicator goes out in the PLAY
mode, the batteries should be recharged.
• If fully charged batteries run down relatively quickly, they
may be worn out and be due for replacement (normally
after charging approx. 500 times). Do not replace the
batteries yourself, but consult your dealer.
• After fast winding «or ^.always press STOP button ■
in order to prevent the batteries from being discharged
completely, which would affect their charging capacity and
lifetime.
CHARGING THE BATTERIES
For charging, only use the enclosed mains adapter
supplying 3 V DC, minuspole ’ - ’ to the centre pin. Serious
damage may occur if another adapter is used.
• Before charging, check that the mains voltage of the
mains adapter corresponds to your local mains supply. If
not, consult your dealer or service organisation. If the
mains adapter is equipped with a voltage selector, set this
selector to the local mains voltage.
• To start charging, insert the DC plug of the mains
adapter into the DC 3 V socket of the cassette player and
connect the mains adapter to the wall socket. Charge the
batteries at room temperature.
• Full charging will take about 8 hours. Charging longer will
not harm the batteries. During charging, the cassette
player may be operated normally.
• After charging, always remove the DC plug from the DC
3 V socket and the mains adapter from the wall socket.
PLAYING BACK CASSETTES
• Connect headphones to the PHONES 0 socket.
• Open the cassette cover and insert the cassette with the
open part facing upwards and the full reel on the right.
• To start playback, press PLAY <
• Adjust the volume with the VOLUME control and the tone
with the GRAPHIC EQUALIZER controls.
• To stop playback, press STOP ■.
• At the end of the tape the PLAY
i button is automatically
released and the set is switched off.
FAST FORWARD WIND AND REWIND
Press REWIND ►► or F.FWD «forfast forward wind. Press
STOP ■ to stop fast winding and also when the tape has
reached its end.
MAINTENANCE
• Clean the magnetic head after every 50 hours of
operation or, on average, once a month by playing through
the cleaning cassette SBC 114.
• Do not expose the set and the cassettes for any great
length of time to excessive heat from heating equipment or
direct sunshine, e.g. in motor cars parked in the sun.
This set complies with the radio interference requirements as iaid
down in European Community regulations.
The type number indica tion will be found at the back of the set and
the serial number Inside the cassette cover.