Coleman 5444 Series - Manual (Page 5)

English-4
Fig. 13
■ Propane cylinder correctly installed. (Fig. 12)
■ Never operate stove with propane cylinder in an
inverted position. (Fig. 13)
Fig. 11 Fig. 10
■ Screw regulator into stove hand tight. (Fig. 10)
■ Remove plastic cap from top of propane bottle and
screw propane bottle into regulator hand tight. (Fig. 11)
Fig. 12
WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the outdoor stove until connection
has been leak tested and does not leak.
Leak Check
WARNING
• BURN HAZARD
• Never leave stove unattended when hot
or in use.
• Keep out of reach of children.
To Light
DANGER
• EXPLOSION - FIRE HAZARD
• Propane is heavier than air and can accumu-
late in low places. If you smell gas, leave the
area immediately.
• Always attach or detach propane source out-
doors; never while stove is lighted, near flame,
pilot lights, other ignition sources or while
stove is hot to touch.
• This stove is red hot during use and can ignite
flammables too close to the burners. Keep
flammables at least 12 inches from the sides
and 48 inches from the top of the stove. Keep
gasoline and other flammable liquids and
vapors well away from stove.
• The stove must not be exposed to flammable
vapors or liquids during lighting.
INSTASTART™
Electronic Ignition Stoves
■ Set on sturdy, flat surface. For outdoor use only.
■ Push igniter button and hold; then open fuel
valve fully. (Fig. 14)
■ Repeat for all three burners.
Note: If igniter fails to light stove, replace the
battery with a fresh AA battery. If the igniter still
fails to light stove, use match to light burner. If
the stove is wet the igniter may not spark.
Fig. 14
Fig. 8
Control Knob Identification
(Fig. 8)
Right
Burner
Valve
Center
Burner
Valve
Igniter
Button
Left
Burner
Valve
CAUTION
• SERVICE SAFETY
• Keep all connections and fittings clean.
Inspect propane cylinder and stove propane
connections for damage before attaching.
• During set up, check all connections and
fittings for leaks using soapy water. Bubbles
indicate a leak. Never use a flame.
■ Close all three burner valves firmly. (Fig. 9)
Fig. 9
Fig. 7
■ Install pot support as shown. (Fig. 7)