Intex 10 FT X 30 IN OCEAN REEF EASY SET POOL SET - Manual (Page 9)

86PO
S AVE THESE INSTRUCTIONS
(86PO) EASY SET POOL ENGLISH 7.5” X 10.3” PANTONE 295U 06/13/2013
English
Page 9
POOL SETUP (continued)
4. Filling of the pool
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain cap
on the outside is screwed on tightly. Fill the pool with no more than 1 inch of water. Check to see whether
the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting up
the pool on unleveled ground will cause the pool to tilt resulting in the sidewall material to bulge
and a potential collapse of the pool. If the pool is not completely level, you must drain the pool,
level the area and re-fill the pool.
• Smooth out the bottom liner wrinkles (from inside the pool) by
pushing out where the pool floor and pool sides meet. Or, (from
outside the pool) reach under the side of the pool , grasp the pool
floor and pull in an outward direction. If the ground cloth is causing
the trouble, have 2 adults pull from opposite sides to remove all
wrinkles (see drawing 4).
• Now fill the pool with water. The pool liner walls will rise while you
are filling it (see drawing 5).
• Fill the pool with water up to the bottom of the inflated ring which is
the recommended fill line level (see drawings 1 and 6).
IMPORTANT
Before allowing anyone to use the pool, hold a family meeting. Establish a set of rules that
include, at a minimum, the important safety rules and general aquatic safety information in this
manual. Review these rules on a regular basis and with all users of the pool, including guests.
The installer of the vinyl liner shall affix on the original or replacement liner, or on the pool
structure, all safety signs in accordance with the manufacturer’s instructions. The safety signs
shall be placed above the water line.
4
5
6